Very simple install – with an impact wrench and an Allen wrench anyone could do this. It just takes time and patience. You can get all the old rubber off the bearing with some patience, so don’t quit early! Watch the video before you start. My total time was about 1 1/2 hours which included finding tools – the longest part was cutting off the old rubber.

I followed the video for the prep and installation of this bearing carrier. I did use a sharp utility knife blade to remove the bulk of the rubber from the bearing and then used a 3M abrasive disk to get clean to the metal. I repacked the bearing in place as described in the video; no problems.

Clamp bearing support mount came as expected. I had my 08 Cayenne base drive shaft replaced under warranty in 2012 due support clamp breaking. It happened again in Dec 17 ! My Porsche mechanic installed this on and seemed to think that it has promise.